Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Updated AC compressor on B21FT 200 1983

posted by  anderssj on  Sun May 4 02:48 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 17:03 CST 2014
[RELATED]

Hi,

The york compressor in our project seems to be on the way out (leaky shaft seal, etc.) Since I have a used DK rotary AC compressor and related parts (from an 85) on a shelf iin the garage, I was wondering if they can be used on our project (83 244Ti)? I also have a line on a PS pump from a 92 (w/ integral reservoir) to replace out leakiy unit--I'm assuming if the AC compressor mounting will fit, then so will the PS unit.

One last question (at least for this post)--will these updates work with the B21 to B23 intake manifold conversion from the turbo-bricks page?

I welcome your advice or suggestions--wouldn't have made it this far without the "board."

Regards,

Steve A-






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Updated AC compressor on B21FT [200][1983]
posted by  anderssj subscriber  on Sun May 4 02:48 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.