Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Distributor question 200 1981

posted by  yrots on  Sat May 3 00:38 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Apr 12 11:19 CST 2014
[RELATED]

I can't for the life of me figure out how to install a new plastic connector thru the distributor wall for the Hall sensor. It is too wide to force thru like I thought it would without breaking. I looked to remove the trigger and sensor from the ditributor so i could slide everything down fron the top into the distributor but cannot see how to remove the trigger. Where is the Circlip the Benley refers to? I don't see anyplace to flip anything off the rotor shaft? This simple problem makes me feel like an idiot.
Dirk






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Distributor question [200][1981]
posted by  yrots  on Sat May 3 00:38 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.