Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel pumps not running when key is turned on 200 1984

On your 83 the Ignition control module sends the ground signal to the fuel pump relay. The ICU must receive a signal from the hall sensor in the distributor before it will power up the relay. Since you jumpered the relay and the pumps run (although the engine won't run properly) the problem must be in the distributor or the ICU. The only source of power to the fuel pumps travels thru the relay. You may want to check the wiring from the distributor to the ICU. Also clean the connector at the ICU.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel pumps not running when key is turned on [200][1984]
posted by  someone claiming to be Roy Dickinson  on Mon Feb 24 18:48 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.