Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Front Seal Carrier Gasket - Dry or With Sealant? 200 1981

posted by  Don Foster on  Mon Feb 17 22:47 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 5 11:53 CST 2014
[RELATED]

The engine designer intended for the gaskets to be used dry.

I've never gone wrong with a very light coating of RTV -- I like the red "hi temp" stuff.

This is not rocket science. Either approach is likely to work perfectly for you. Sealant is advised when you're reusing a gasket surface, such as the pan gasket.

Another advantage of a light RTV coating is that it does NOT stick well to metal, even though it seals well to metal. When you next remove the housing, the gasket will readily peel away from the metal surface.
--
Don Foster (near Cape Cod, MA)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front Seal Carrier Gasket - Dry or With Sealant? [200][1981]
posted by  DougC  on Mon Feb 17 15:24 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.