Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 10/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

both filaments in brake bulb light up 200 1987

posted by  B.C. on  Sun Feb 16 17:58 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

As was said, check and clean up all the grounds. This means using a pencil eraser on the copper places where the bulb holder connectors fit on. Also you might bend those connectors downward just a teeny bit, so the exert just a little more pressure on the circuit board.

Check also the color of the brake light bulb holders. White on the right. If they are reversed, they might still fit in but weird electrical things happen.

Good Luck,

Bob

:>)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New both filaments in brake bulb light up [200][1987]
posted by  ribnab  on Sun Feb 16 15:18 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.