Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 3/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Flywheel resurfacing advice, please 200 1979

posted by  walrus3 on  Wed Jan 29 15:23 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

If the locating holes for the dowel pins go all the way through,
have them knock them out from the back side and save them for you.
While you could probably tolerate a stepped flywheel it is not really
a very good deal.

The heavy tool support is good but the difference between cutting and
grinding is great and you will be a LOT better off getting it ground.
Even with the best of heavy duty carbide tools, hard spots respond to
machining a LOT different than to grinding. Get it ground if you can.
--
George Downs, The "original" Walrus3, Bartlesville, Oklahoma






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Flywheel resurfacing advice, please [200][1979]
posted by  pierre  on Wed Jan 29 12:11 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.