Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Going to replace heater in my wifes 84 240 any hints or tips?

posted by  Goldy on  Thu Jan 23 21:16 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

check the archives - search under heater fan replacement - or something near that.

This item has been written about so often that the archive contains all the shortcuts.

The easiest way is to cut out the ends of the fan housings with a dremel tool, remove the fans, and then remove the fan motor. Make the holes in the end large as you can, so that the fans will come through them.

Just before you remove or completely cut out the end pieces, drill 3 pairs of holes (1/8" +-) one hole outside the cut line, the other hole insode the end piece. The two 1/8" holes should be about 3/8" apart.

To re-assemble, Have small nylon tie straps that fit through the holes. Tie strap the end pieces on, then seal the cut with silicone or caulking.


This method is WAY easier than tryingto undo all the clips and removing the housing parts...

There are plenty more tips in the archives.

good luck






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Going to replace heater in my wifes 84 240 any hints or tips?
posted by  someone claiming to be Chris Lindsay  on Thu Jan 23 12:38 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.