Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2019

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Crankcase oil separator ventilation box replacement

posted by  B.C. on  Sun Dec 1 17:20 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

Diego -

If you are planning to clean the throttle body, this is a good time to do it. Access is easier when the throttle body is off.

Also, the ECU engine temp sender is in there, too, if your car has one.

I would get a new oil separator box and not spend a nanosecond on the old one.

On the B230F the separator is bolted to the block with one or two 10mm bolts. Hard to access. I got a 10mm flat ratchet 12pt wrench for that job. It was about 10 bucks, and worth it.

Good Luck,

Bob

:>)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Crankcase oil separator ventilation box replacement [200][1981]
posted by  DougC  on Thu Nov 28 11:43 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.