Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2009 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Shutter under hump while accelerating from stop 700 1987

posted by  someone claiming to be bagle on  Thu Jun 27 09:50 CST 2002 [RELATED]

This problem is addressed in the FAQ, reprinted below for your enjoyment. I was having the exact same problem. I shimmed it up 1/4" and that cured it. Note: I had to use longer bolts to get proper thread engagement.

"Driveline Take-Off Vibration: Shimming May Be Required. From Volvo Technical Service Bulletin 45/102 Jan '91. [Symptom:] Take-off vibrations at low speed, especially with high acceleration and/or heavy load, can occur in some cases. [Solution:] The level of vibration can be reduced by changing the vertical position of the center support bearing. Best results differ from car to car. Start with a change of 6mm (1/4") upwards. If results are not acceptable, try positions from 5mm (3/16") downwards to 12mm (1/2") upwards from the original position. Note that clearance between drive shaft and fuel lines must be at least 20mm, and between drive shaft and the fuel tank at least 16mm. Shimming upwards should not exceed 12mm (1/2") and after re-positioning the center support bearing housing should not contact the floor pan."


bagle 745t, aw71






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Shutter under hump while accelerating from stop [700][1987]
posted by  jneal  on Thu Jun 27 05:02 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.