Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Engine mount replacement. 200 1988

posted by  bb1551 on  Sat Jun 15 07:39 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jun 21 12:13 CST 2014
[RELATED]

I would agree with rhare's reply. All 3 mounts were broken on my '86. The engine was resing on the front end cross beam and the automatic transmission was on the tunnel cross beam. I found this by investigating a clunking noise. The oil filter was resting on and chafing against the RH mount. I didn't notice the vibrations it caused or connect it to the shift lever rigging being off. You could get 1st gear in the 2 spot. A little more time and an engine change was in the cards.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine mount replacement. [200][1988]
posted by  archie777  on Wed Jun 12 11:38 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.