Please help... 86 740 GLE B230F EZ117K I am receiving no pulse to the injectors. Diagnosed using injector noids. I have put a lot of heart and soul into this car and am on the verge of losing my mind. I recently replaced most underhood wiring after determinig existing wiring faulty (insulation gone exposing wires, which really sent some bad signals to ECU from AMM). I spliced new wires into the bad segments and she ran pretty good, not considering the slight miss and extremely rich fuel mix I've experienced for quite some time. All of the sudden she died with no start (engine turning over no start). Pulled wiring again and tested continuity to ECU; all wires test fine (0.2 Ohms on all wires) jumpered pins on relay for Fuel Pump; pump ran no start. New parts installed: Reb Distributor Plugs/wires/cap/rotor Fuel Press Regulator Cool Temp Sens New Fuel pump & relay Cleaned Idle Air Ctl Valve Head Gask & Stem Oil Seals O2 sensor Ahhhh!