Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Question,Don Foster/solder guru 200 83

posted by  someone claiming to be RR on  Thu May 31 01:28 CST 2001 [RELATED]

Good morning Don and Bricksters,

Among my latest projects on my recently recomissioned 242glt is fuel delivery issues.Specifically in-tank and main fuel pumps.Replaced in tank pump and noisy main persists as well as some hesitation on less than half tank.

Anyway,while replacing several times,long story,the main fuel pump I was changing out the valve in the pump which required bending the +/- prongs and ended up breaking the prongs off.Can I resolder these prongs.I realize the danger of working with heat around gas.But the pump is good and I hate to trash it

Thanks

RR





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question,Don Foster/solder guru [200][83]
posted by  someone claiming to be RR  on Thu May 31 01:28 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.