Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 6/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: Sealing replacement windshield wiper motor 200 84

posted by  someone claiming to be Art Benstein on  Tue Dec 19 07:06 CST 2000 [RELATED]

Zee, the shaft housing is surrounded by a tight fitting grommet placed in the interior body skin. There is/was no additional sealant. Of course, if the grommet is dried out it would no longer seal well, or if the grommet is missing, I'd guess something very pliable and sticky might be used around the shaft housing -- say butyl rubber from a windshield job...

Hey, Zee, do you think I could market a moisture detector alarm with sensors placed under the carpets in maybe 4 places?? Are we the only bricksters who hate rust worse than disease?

Art Benstein near Baltimore





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Sealing replacement windshield wiper motor [200][84]
posted by  someone claiming to be Zee  on Sun Dec 17 23:57 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.