Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: Advice on a 244 turbo 200 84

posted by  someone claiming to be Les Lyne on  Mon Dec 18 10:51 CST 2000 [RELATED]

Last time I checked, "Gapa" (www.gapa.com) had a clutch kit for $100.00 - included pressure plate, disc, TO bearing, and an alignment tool. I assume the quality is acceptable; if it is, that's a pretty good price (1 1/2 years ago I spent $200.00 on a 1974 Alfa GTV clutch set).

I echo Don's sentiments: Absolutely replace the rear main seal when the transmission is off the engine. And you might want to consider replacing the 4th gear OD switch (maybe even the solenoid) at the same time.

A question to the guys who have experience in removing an M46: Is it really that difficult? Recently I helped a friend replace his rear main seal on a 1986 244 that had an auto transmission. With a regular floor jack and some elbow grease, it wasn't too tough to get out at all - but maybe an M46 is more difficult?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Advice on a 244 turbo [200][84]
posted by  someone claiming to be Rob Hanley  on Sun Dec 17 18:43 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.