Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: rear control arm bushings question 200 87

posted by  someone claiming to be dave lotman on  Mon Dec 4 02:10 CST 2000 [RELATED]

Hello Scott,

Sorry I didn't see my email until today. I bought my press from Baum Tool

in Florida. As you see below you can rent it from Duane. If you don't

plan on doing more than one car this is probably your best bet. IPD used

to rent this tool but they don't anymore. Make sure you soak the bushing

with a good penetrant for a day or two before you do the job.

Dave 82 242ti





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rear control arm bushings question [200][87]
posted by  someone claiming to be Scott  on Fri Dec 1 07:35 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.