Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: pressurize cooling system - how? 200 93

Don,

I don't know... I may have to give you my Fedex address for that cold one - I'll take afternoon delivery - I don't fancy beer with my breakfast.

I had the shrould, fan and belts off and was able to get face to face with that weep hole and it looked bone dry. When I probed it with a piece of wire there was just a smidgen of white powder that fell out. I don't see how it could it be so dry and be culprit while the bottom of the timing belt cover was still wet. I assume there is just the one hole,of course. Tomorrow I'll take it for a drive and then put something under the weep hole and see if it collects any coolant. I've actually felt desperate enough to go out there and lay on the ground with a light for a couple of hours and wait for it to start seeping. But then I realize I have a life....

Robb






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New pressurize cooling system - how? [200][93]
posted by  someone claiming to be Robb  on Sat Dec 2 12:38 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.