Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 12/2000 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: wheel bearings 200 1992

posted by  someone claiming to be Mike on  Wed Nov 29 10:32 CST 2000 [RELATED]

>with a Bentley's at the elbow

Marcus,

Be aware that the Bently manual reccomends removing the calliper by disconecting the brake lines. If you do this, a complete brake bleeding will have to follow. If you carefully remove the calliper without cracking the brake lines and then hang it up using mechanics wire (an old coat hanger), you can avoid cracking the system thus avoiding the bleeding procedure... a messy and time consuming job. Try not to overstress the brake lines while doing this.

Bearing replacement/repacking is pretty straight-forward. Bentley's procedures will get you through it.

Good luck,





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New wheel bearings [200][1992]
posted by  someone claiming to be Marcus  on Wed Nov 29 03:16 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.