Volvo RWD ALL Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2001 ALL INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Metalworking tool suggestions ALL All

posted by  someone claiming to be Zee on  Tue Nov 21 23:41 CST 2000 [RELATED]

Need ideas for what kind of tool (like a drill bit) I can use to cut out inner fender rust that's tucked up behind the wheel flare.

Can't get a cut off disc in there, only a drill. But I don't want to drill holes...more like slice sideways with a bit in order to trace around the rusty metal.

the new tool on the block -- the Roto-Zip -- is more the idea of what I need. don't want to spend $100 for a set up like that, though. Besides, that tool doesn't mention metal work in its featured uses.

Is there some type of sideways cuting bit I can use with a typical 3/8" drill?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Metalworking tool suggestions [ALL][All]
posted by  someone claiming to be Zee  on Tue Nov 21 23:41 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.