Volvo RWD 700 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 11/2000 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re: Rear Transmission Mount 700 89

posted by  someone claiming to be Greg Clink on  Sat Nov 18 02:45 CST 2000 [RELATED]

The hanger bearing for the driveshaft should allow no more than about 1/2 inch of play. I would say if you have over 150K on the car to suspect that first. If your driveshaft ever hits the tunnel or bangs under there, you may think about replacement. Mine banged for a couple of years before I changed it.

The tranny mount is relatively cheap, so I changed mine at the same time. You'll eventually need to change it anyway.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear Transmission Mount [700][92]
posted by  someone claiming to be Mark  on Thu Nov 16 16:34 CST 2000 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.