Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2014 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Solenoid wiring 900 1993

posted by  jwalker on  Sat Jan 6 07:29 CST 2024
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jun 6 08:39 CST 2014
[RELATED]

Bill,

What hot sun? ☀️ 🌞 We live in New England. 🙃

This might be helpful. Just remembered this drama. I had a similar issue with my 90 240. No OD. I too thought it was the OD solenoid. Was preparing to replace it. On the 240 you could reach it with jackstands (I’m sure ramps would work) but it is in a difficult spot. So, I considered replacing it or installing the bypass kit. Then I got lucky. Read on the BB about folks having issues with the wiring running to the solenoid. The wiring rubbed on the almost sharp bottom edge of the transmission tunnel near the shifter opening. Wire was bare and badly corroded. Replaced wiring and voilà OD was back! BTW - Another spot the wiring can go bad is where it connects to the solenoid. This wiring issue might not apply to 940’s but still worth checking out!

Personally, I would only do the bypass as a last resort. Try every other possibility first.
--
Will I buy another Volvo??? We'll see....






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Transmission overdrive kit for 945 B230FT ? [900][1993]
posted by  B.B. subscriber  on Fri Jan 5 10:51 CST 2024 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.