Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2017 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Fuel Line To Use For Pulse Dampner Replacement? 900

posted by  maplebones on  Fri May 6 09:32 CST 2022
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 22:53 CST 2014
[RELATED]

Hey Spook,

I take your point that if in doubt, it's always better to err on the side of caution.

In this case, if the feed line to the main pump is only under a few pounds pressure and the original equipment was 30R7, then replacing it with the same would not be economising.

My local Napa dealer carries 1/2 inch ID 30R7, rated at 35 psi, but not 30R9, and neither can they source it.

It's made, as you pointed out, but where to buy it is another question. The Continental you referenced is available only in a 50 ft reel, according to the chart.

Peter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel Line To Use For Pulse Dampner Replacement? [900]
posted by  jd620  on Mon May 2 08:43 CST 2022 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.