Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2017 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Intermittent grinding noise after transmission mount replaced 200 1987

posted by  bluesedan on  Mon Oct 15 15:45 CST 2018
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

1987 244
155,000 miles
Just replaced rear transmission mount after noticing it was done. It was the original square mount. I replaced it with a Swedish made mount. Before I changed the mount out (it was broken on the side that connect to the transmission) there was a random clunking sound on take off sometimes.

I changed the mount and now there’s a grinding noise once I get to around 30 and then it stays grinding as I come to a stop and also persists when I put in neutral. Reviving it will keep the noise around in neutral. I put back in drive and at times it goes away.

I drive back to my lot and can’t recreate the noise.

The driveshaft rubber mound and spring appear to be fine (mount isn’t torn or cracking, spring is in good shape and not distorted.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intermittent grinding noise after transmission mount replaced [200][1987]
posted by  bluesedan  on Mon Oct 15 15:45 CST 2018 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.