Quantcast
RWD - #2 coil not firing, all others OK

Volvo RWD S90-V90 Forum

INDEX S90-V90 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

#2 coil not firing, all others OK S90-V90

hello good people of the brickboard. I am currently woring on a 97 V90 that indicates a check engine code of P0302 (cylinder #2 misfire) upon initial
diagnosis I found the #2 coil not firing at all, and swapping with several known good coils, no coil will fire in the #2 position. I measure 12V at pin 15(+) of the coil, but it seems no ground pulse from (and here I'm in unfamiliar territory)
the ignition module is getting to pin 1(-) of the coil. I am assuming that wire
is broken some where in between. I am hoping to simply run a new wire from the ignition module to the #2 coil, but I need wiring diagrams with pin outs of the module, and the location of the module to complete the job. I welcome your
comments, and suggestions, and any helpful info. thanks

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New #2 coil not firing, all others OK [S90-V90]
posted by  someone claiming to be dougieslugie  on Tue Jun 12 10:53 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts