Quantcast
RWD - Missing speed signal but speedo works!

Volvo RWD 900 Forum

INDEX 900 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

Missing speed signal but speedo works! 900

Hi guys,

I have been trying to fix my 960 Volvo. The car is in limp mode, OBD1 reads:

A1 232 missing speed signal, this code cannot be cleared!

A3 155 rear speed/abs sensor short circuit, I have checked the wire from the sensor to the trunk at the small connection box. The sensor itself gives resistance within the the normal range (1300 approx). I also check the voltage of the wires from the trunk to inside the car, and they give 0 Vs for the ground and 4.8 Vs for the green-white ABS wire, which I believe they are good. This code 155 is clear-able, but it comes back after driving.

The car has no ABS light, and the speedo works as well. My cruise control doesnt work and show no codes.

Any suggestions?

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Missing speed signal but speedo works! [900]
posted by  Ozzy Oz  on Sun Mar 5 17:37 CST 2017 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts