Volvo RWD 700 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 1/2017 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

740 Instrument Cluster wiring 700

posted by  Volvodad on  Mon Nov 23 23:32 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 16:18 CST 2014
[RELATED]

Disconnect the wiring from the gauge. Use your multimeter to check cold resistance at the sender terminal to engine ground. Then check the disconnected wiring at gauge between your Yellow and Black wires. Should be the same. Check again after a drive has heated the oil up - minimum 10 mi. You can then call Egauges and ask if those numbers seem right. If sender resistances are ok you must have either no 12V to gauge (easy to check) or a dead gauge, or the wrong sender resistance range for that gauge.
--
Bob: Son's XC70, my 83 244DL, 89 745 (Chev LT-1 V8), 98 S90 (recently sold) and 2010 XC60. Also '77 MGB and four old motorcycles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 740 Instrument Cluster wiring [700]
posted by  Roger Brown  on Fri Nov 6 23:22 CST 2015 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.