Volvo RWD 200 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 3/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ignition timing - mark doesn't line up 200

I thought about that, but...

1. If the car runs well, the ignition is close to where it ought to be...so when #1 fires, the engine has to be in the vicinity of TDC on the compression/power stroke...which means the timing mark should be in the right place, no matter how out of phase the distributor is...

2. The timing mark ought to show up either on top (where it belongs) or 180 deg from that...(ie, TDC for one of the other cylinders)...when I put the inductive clip on different plug wires, it shows up +90 or -90 from top...I don't think it should ever show up in those positions no matter what cylinder you are clipped to.

BTW my timing light is the basic type..no advance adjustment or anything fancy.

I think I must have a crank pulley that is out of phase somehow.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition timing - mark doesn't line up [200]
posted by  swebb CO  on Thu Nov 6 18:34 CST 2014 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.