Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 7/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Introduction... and questions regarding rough/lumpy idle 200 1993

posted by  OzzieH on  Wed Oct 23 11:35 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:16 CST 2014
[RELATED]

Machine Man is referring to the throttle plate stop screw.

You have done almost everything else. I don't know the correct order of the next steps, but I might consider the following:
1. throttle plate stop screw adjustment per Machine Man
2. New ECT sensor (from my reading in the Bentley manual, the main three sensors for engine mgmt appear to be AMM, o2 sensor, ECT sensor)
3. Trying different AMM
4. If you decide to purchase a reman AMM, I had very very bad luck with Programma. The only reman AMM I would consider would be the Bosch unit (look at Amazon.com price--much better)
5. Clean injectors
6. New sock filter on in-tank fuel pump






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Introduction... and questions regarding rough/lumpy idle [200][1993]
posted by  mike.volvo.240  on Tue Oct 22 07:22 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.