Volvo RWD 900 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2015 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Intake Manifold gasket? 900 1994

posted by  Volvo From Heck on  Wed Jan 2 18:58 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 20:56 CST 2014
[RELATED]

I wonder if you installed the gasket front to back---I think it can fit over the studs that way but it looks not quite right. There is a part of the gasket that fits over a freeze plug on one end and you snip the corresponding part at the other end (been a while--think it gets snipped at the temp sensor). That gasket may double for use in a carbureted model--I don't know for sure. As for brand--you can't go wrong with a Volvo original part--but one from any major gasket maker should work ok. -- Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Intake Manifold gasket? [900][1994]
posted by  The Rod  on Wed Jan 2 16:34 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.