Hi guys,

Thanks for all the tips...I'm still however in the same boat...

The wheel cylinders have been overhauled and new bleed screws installed.

I removed the rear proportioning valve and cleaned it out best that I could with
No success.

I removed switch from H block and tried rebleeding with no success.

I then removed the little pistons from the H block, and assembled H block without them and upon bleeding, there is definately more fluid coming through
To the left rear wheel cylinder but the system does not build up pressure!
In other words, the pedal sinks to the floor with no build up at all after
Bleeding.

PLEASE help...

Thanks