Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

installing cruise control kit 200 1993

posted by  Ron J on  Fri Jun 17 14:37 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:20 CST 2014
[RELATED]

rhaire is correct. It's plug and play. Their is also a conduit provided for the vacuum line hidden in the wheel well close to the drivers side door. It has a little rubber cap that looks like a dunce cap. Don't through that away. Snip a small hole in it and then fish the vacuum line through to the passenger compartment. It comes out just above the fuse panel. Put the dunce cap back on the prevent any water from migrating through to the fuse panel.

I'm not sure but I think I purchased my cruse control setup from rhaire. I know it came from Fl.

Works fine, no problem,

Ron J






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New installing cruise control kit [200][1993]
posted by  WagonWoman  on Fri Jun 17 07:47 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.