Volvo RWD 120-130 Forum

INDEX FOR 2/2026(CURRENT) INDEX FOR 6/2023 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Decision time on the '68 dual line MC 120-130

posted by  red92s on  Thu Dec 16 03:27 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 18 13:02 CST 2014
[RELATED]

You don't need an adapter as Lukeball mentions (at least, I didn't). My RX7 already had two vertical holes with diameters and spacing very close to that of the mounting bosses on the firewall.

1) I'm guessing you have a remote (not firewall) mounted booster, like most 122's? My car has a Lockheed remote mounted booster. When I redid the brakes I bypassed it, but only because I wanted to remove potential sources of confusion while I troublehsot and tested the new MC setup. The booster has since been rebuilt and will be reinstalled. With this type of setup, you will only be boosting ONE circuit (typically the front) since the booster has only one inlet and is in place AFTER the MC.

2) I believe it is the same

3) I think that is what I ended up doing. Removed the clip that retains the pushrod on the volvo MC, and used it on the RX7 MC.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Decision time on the '68 dual line MC [120-130]
posted by  tdskip subscriber  on Wed Dec 15 16:12 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.