Hello All,

Lately I've had a rash of car problems that I have had some difficulty with. Thanks to the kind souls on the BB, we've vanquished these obstacles but there's always a new one that pops up.

Over the last year or so, fixing or diagnosing various problems under the dash, I've had to lay my old creaky torso in the driver's footwell. In doing so, I've managed to finally tear off the rocker molding. I've purchased a slew of new clips 1304520 but for the life of me cannot figure out how they are to be installed.

Searching both BB and turbobricks, I get that I should put them in warm water to soften them up, but I'm not clear whether they go in the rocker molding first or whether I insert the clips into the holes in the body. One poster commented that they're to be turned 90 degrees????

Can anyone give this thickhead a very clear and understandable procedure on clip and molding installation.

Thanks much,

Marty