Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

TRE and Ball Joint question

posted by  Gr8Scot! on  Wed Oct 6 04:00 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Aug 17 07:15 CST 2012
[RELATED]

I just replaced the TRe and ball joint on my '92 240 sedan and have the following questions:

I put the TRE on completely and I'm now having troulble getting the ball joint to line up with the control arm, should I disconnect the TRE and attach the ball joint first?

The new ball joint came with new bolts to attach it to the control arm, they seam to have a head that is too big, the original bolts nearest to the strut were a flat head type bolt, use the new or reuse the old?

Similar question for the four bolts that hold the ball joint to the strut mounting plate, Bentley says to NOT reuse the four bolts but new ones don't come with the ball joint, reuse the old or find new bolts?

Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New TRE and Ball Joint question
posted by  Gr8Scot!  on Wed Oct 6 04:00 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.