Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2011

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Balancing a drive shaft

posted by  KlausC on  Thu Jul 1 10:18 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

I installed a center carrier and bearing on my 1967 220. I was remiss in marking all of the joints, which I got some of them wrong. I took the car up to 70 mph and feel a slow vibration from the rear, shift lever is quite smooth.

I found out through your help that the U joints need to be lined up, which they were not. So I did that. Vibration continues, and now the pinion seal is leaking fresh oil.

How do I balance the shaft? Do I take one end off the tranny, rotate it 180 degrees and take it up to 70? Do it again with the rear?

Terribly lost...

Klaus
--
Why are Volvos so endearing? Its just a car.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Balancing a drive shaft
posted by  KlausC subscriber  on Thu Jul 1 10:18 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.