Volvo RWD 444-544 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2003 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Removing pedal shaft 1960 PV? 444-544

posted by  someone claiming to be Rockmonton on  Sun Dec 27 10:30 CST 2009 [RELATED]

Hey guys, i've managed to find the snap rings under the grease that allows me to remove the pedals themselves, but I was wondering if anyone knew how to pull the actual shaft that they all pivot around, off. I'm mocking up my new frame rail/rear of the lower control arm mounts (3x1" 11ga hot rolled box x 7' per side)

and i need to notch out a section of the frame spars to install this 1/8" plate box i'm building up, but this pedal mounting tube is definitely in the way.

Any tips/tricks?

and here is about 1/2 of the box for the drivers side rail. the angled section is where the plate with the captive nut for the subframe sits. the frame rail gets welded into the little notch on the plate behind the angle.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Removing pedal shaft 1960 PV? [444-544]
posted by  someone claiming to be Rockmonton  on Sun Dec 27 10:30 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.