Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

CIS/K-jet injection hose size

posted by  Mandon S. Brontes, esq. on  Sat Oct 24 06:46 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Mar 24 12:16 CST 2012
[RELATED]

Stupid K-jet. If it weren't for the crummy nylon/plastic/teflon(?) lines, it'd be perfect.

What size ID of the lines that run from the fuel distributer to the injectors on a NA 240? 6mm? 8mm?
I know that DeLorean, VAG, and other cars from the early 80's have the same injection setup, and some of them have much better looking plumbing than the Volvo version.

Has anybody just replaced them with 1/4 or 5/16ths inch high-pressure hose? It's seem to be a lot cheaper/easier to find than metric.
--
1980 244 DL






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New CIS/K-jet injection hose size
posted by  Mandon S. Brontes, esq.  on Sat Oct 24 06:46 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.