Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2007

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Will a Bernzomatic work for broken off bolts???

posted by  TONY H on  Mon Jul 27 08:38 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

Vise Grips. They lock on. Burnzomatic gas could work. problem is that most of teh Valve ends you put on them fan the flame out too far.
These little bolts should not have been in too tight. I wonder/hope if you get a small pair of Vise Grips and clip it on teh threads right at teh Block it will let go for you ...especially after using Kroil....very good stuff.

Try to loosen a bit then tighten then loosen then tighten.
--
'75 Jeep CJ5 345Hp ChevyPwrd, two motorcycles, '85 Pickup: The '89 Volvo is the newest vehicle I own. it wasn't Volvos safety , it was Longevity that sold me http://home.no.net/ebrox/Tony's%20cars.htm






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Will a Bernzomatic work for broken off bolts???
posted by  Son Of Bonzo  on Mon Jul 27 07:04 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.