Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2024 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Temperature Compensation Board, &c. 200 1987

posted by  KG4BKD on  Mon Nov 24 11:51 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 29 07:10 CST 2011
[RELATED]

Hello,

I have a quick question about bypassing the temperature compensation board on the 86+ 200's. My gauge has been quite screwy lately and I thought maybe I better try this fix. After doing it, the needle now climbs to just shy of the red zone immediately (within seconds), even after the car has been parked all night. My question is, should I have removed the board entirely after jumping the terminals 1 and three? I gathered from the photos that it was to be put back in place after jumping the two terminals...but maybe not? If I have in fact done this correctly, my next suspicion would probably be the sender (I have swapped out a couple of actual temperature gauges already to no avail). I just thought I'd ask before I tear into the motor...

Thanks to anyone in advance!!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Temperature Compensation Board, &c. [200][1987]
posted by  KG4BKD  on Mon Nov 24 11:51 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.