Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

how to remove a stuck rpm sensor? 200 1990

thanks to the great writeup by Ryan_R, i've been able to remove the bolt that holds in the rpm sensor (5 minutes and most of that was to get the right tools out).

however, no matter what i've tried, i can't get the sensor out!

i had a little wiggle room to start, but couldn't get anywhere, and so sprayed it with pb blaster, and lost what wiggle room i had.

it's cold and snowy here in western ny, if that makes any difference...

my friend broke the bracket it sits in on his, and i don't want to make that same mistake, because now he has to drop the transmission...

i'm at the point where it's costing me a good bit to not have junior on the road... any last suggestions before i get it towed?

thanks!
curiousheights
--
'84 244, Peter, never drove. Robbed to fix Paul, '86 244 - drove for 2 years; holey saint now, passing parts to Paul Jr, '90 244, now driving. Friends w/ '90 245, jokingly aka Mary, (pregnant sedan & completes PPM trilogy). Daughter to unnamed '90 745.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New how to remove a stuck rpm sensor? [200][1990]
posted by  curiousheights  on Tue Dec 18 00:41 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.