Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2001

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ANSWER Window play

posted by  ODGuru on  Tue Aug 21 00:36 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 4 18:52 CST 2014
[RELATED]

Hopefully you will not find any too badly ripped up motor mounting holes.

I had the same problem which was caused by loose motor mounting bolts.

Before you tighten the bolts, run the window up to about 1/4 inch from the top. Then have someone with their hands on both sides of the glass pull it forward with the door open as you finish powering it closed.

That will set the window in its proper place so you will not have to adjust the limits after tightening the bolts.

If your holes are beat up, another washer that fits the indent allows a good grab.

Duane

This post has been marked as an answer to the original question.

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED Window play
posted by  B0RK ^3 subscriber  on Mon Aug 20 15:30 CST 2007 >
  • New ANSWER Window play
    posted by  ODGuru  on Tue Aug 21 00:36 CST 2007 >
  • New Window play
    posted by  Volvony subscriber  on Tue Aug 21 05:16 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.