Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2010 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Upper control arm bushing 140-160

posted by  cef2lion on  Wed Aug 15 01:13 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 9 05:17 CST 2014
[RELATED]

A slot in the ball joint press is what I viewed as a solution except it isn't my press. If need be I might have to buy one and cut it. I assume there is/was a special tool for this purpose? My lower bushing were the bad ones. The tops ones looked ok but I thought I would change them out. Had I known I might have left them be for now. I don't see how one would do it even with a shop press unless you spanned the A arm to keep from bending it.

Craig






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Upper control arm bushing [140-160]
posted by  cef2lion  on Tue Aug 14 01:21 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.