Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 1/2008

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help with B20 bolt sizes, I'm very confused! Are they metric or standard?

posted by  someone claiming to be William Walters on  Mon Jul 31 11:56 CST 2006 [RELATED]

I'm very confused about the variety of bolts in my B20. The engine has been replaced and rebuilt, and I am having a heck of a time figuring what hardware goes where. Everyone says it's Swedish, so it must be metric right? Well after much trial and tribulation, I've determined the flywheel crank bolts to be 3/8 24 standard! Next hurdle the engine transmission bolts, the one's that go into the block are metric 10 x 1.75. The lower ones that go into the aluminum brace are 5/16 standards! Now I've noticed the head bolts are standard! What is going on here? Any help please?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help with B20 bolt sizes, I'm very confused! Are they metric or standard?
posted by  someone claiming to be William Walters  on Mon Jul 31 11:56 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.