Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 4/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

any tricks for turbo o2 sensor replacement? 200 1983

posted by  someone claiming to be chris with an '86 245 on  Thu May 4 02:43 CST 2006 [RELATED]

hey guys, i got a new o2 sensor for my turbo and this seems like its going to be the most rediculous thing to try and change. It is located on the underside of the exhaust manifold right in the center....placed above the oil cooler lines and above/next to the oil filter. I have tried 3 different types of o2 sensor sockets and there is just not enough room up there to do anything. it looks as if i'm going to have to remove the oil cooler lines, filter, and the oil drain tube for the turbo to even get a better angle at it. are there any better ways to go about this precedure? seems to be a lot more of a hassle than it should be. any suggestions would be great, Thanks





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New any tricks for turbo o2 sensor replacement? [200][1983]
posted by  someone claiming to be chris with an '86 245  on Thu May 4 02:43 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.