Volvo RWD S90-V90 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2004 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Good progess! S90-V90

posted by  david hunter on  Wed Feb 1 16:53 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 30 22:10 CST 2014
[RELATED]

They were 7mm 1.0 pitch about 2" long. Got them at Lowes. Slightly shorter would have worked but that was the length they had there. They only have to be about 1/2" longer than the actual bolts. When drawing down the upper head it is important to alternately and evenly tighten the bolts just a very little bit at time so that not to much pull is applied to any one bolt. I set the rear cam seal (there is only one and its on the exhaust side) in place before setting down the upper head. This avoided the difficult job of trying to push it in afterwards.

Are contemplating this job?
--
David Hunter






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 97 V90 Installing head, Where is the timing mark??? Yikes [S90-V90]
posted by  david hunter  on Sat Jan 28 07:46 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.