Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Machine shop liability

posted by  illbird68 on  Thu Dec 29 05:11 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 25 12:56 CST 2008
[RELATED]

well sorry man...my diesel experience is limited, but the head milling that I have seen on them was on massive (off rd equpiment). I think some of those actually had hemispherical combustion chambers and massivly domed pistons...and could be milled...but then again those were designed to run generators and pumps and loaders for tens of thousands of hours and then to be rebuilt...so they probably had lots of extra material for that. My diesel (86 ford ranger turbo ....2.3 liter mitsubishi) was never apart...so i dunnno what that thing looked like inside...too bad I couldn't hold onto it...what an odd ball vehicle...less than 100hp but towed my 3600lb pontiac....
are you gonna be able to get a new head for that thing? it sounds like a pretty exotic piece...second...what state are you in? I have a great shop in MD if that helps.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Machine shop liability
posted by  Rludwick subscriber  on Thu Dec 29 02:30 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.