Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2006

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

E-code Headlamp assembly

posted by  Michae1 on  Wed Nov 16 15:25 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Feb 28 08:41 CST 2010
[RELATED]

E-codes don't use any parts from the US headlight assembly.

The e-code headlight uses a trim piece along the top (or some have a single L shaped piece that goes along the top and down the side). This does not transfer from the US spec lights...not even close. It's e-code specific.

The e-code turn signal has a trim piece along the top. This piece DOES swap between e-code and US turn signals, even though the turn signal assemblies are totally different, and the lenses are different too.

The e-codes should have three studs sticking out that use 10mm nuts like the stock headlights. My OEM Volvo/Cibie e-codes still had a plug on the turn signal side, and it was plug 'n play wiring for the marker lights. I had to splice an H4 plug in place of the US spec headlight plug however.

It's an easy swap.
--
WANTED: #572 ECU from LH3.1 M47 '90-'93 240






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New E-code Headlamp assembly
posted by  rayco  on Tue Nov 15 13:31 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.