The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Water pump installation details 900 1993

Dear jd620,

Hope you're well and stay so!!! I use an hydraulic bottle jack and a short length of 1" x 2" lumber (the board) cut to length. I use gasket adhesive to secure the gasket to the pump. I then emplace the pump, using the bolts through the oblong holes. I snug, but don't tighten those bolts.

I then position the jack and the board, so that one end of the board is flat against the pump's bottom. I then use the jack very, very slowly to raise the pump, until I can start the bolts, that go through the round holes.

This method frees-up both hands, so I can use one to keep the pump pressed against the block while I get all of the bolts into position and tightened.

Water pump installation is most easily done by a human with three or four arms!!!!

Hope this helps,

Yours faithfully,

Spook






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.