The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wiring a 'prime' button to the EFI relay without nuking the ECU

Hi Will,

Did you rewire the Regina to B230FT (MFI) specs?

If you wired the same as the B230FT MFI
Yes, grounding 86/2 of the Fuel relay would run the pumps.
You would run both pumps and the O2 heater and apply a ground to pin 20 of the fuel ECU. That's uncharted territory, Signal ground is not chassis ground.

Safer would be to apply 12 V direct to the battery side of Fuse 11
and you would run both pumps without grounding ECU pin 20.
To be safe your jumper should have a 15 amp fuse.
You'll need a husky push button switch.

Have you measured current at Fuse 1 and Fuse 11 to gauge the health of the
pumps?

Here's what I get:
Fuse 1 = 10.5A Both pumps,O2 sensor, AMM, PTC, both ECU's, RSR coil, IAC.

Fuse 11 = 3.5A Only the in-tank pump

I can pull fuse 11 and start and run the engine.

Disclaimer: Do these mods at your own risk

Good luck and happy holidays, Bill






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.