The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

upper strut mounts 200 1992

Hi Folks,
thanks for previous advice on the strut insert spacers. If I had read a little more and seen daveshan site I would not have removed the strut from the car per the Haynes manual. Oh well - side two will be easier. I noticed some play (side to side)between the strut mount inner race and the strut rod. I get the same amount of play on both the old and new strut. Can the inner race of the upper strut mount wear that much? The bearings are fine and not separated from the rubber. I think the fit should be much better than it is but maybe this is normal and I am overly concerned. could this be the source of the rattle noise in the front end over rough road surface? If I need to replace the mounts should I go with the OE or the much cheaper aftermarkets. There is 157k on the car and if the piston slap doesn't drive me nuts I may keep the car for awhile.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.