Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2012 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

740t crankcase pressure-stumped! 700

Okay, on my 90 740t. The car fails the jiggle test. Pulled the small hose from the "non-flame trap" Y, the brass fitting to the manifold is clear. Replaced the hose, but found out the small nipple on the Y was clogged solid. Opened that up, cleaned it. Also ran a tube down to the hose going into the breather box and blew smoke in. Smoke came out the oil filler so the breather box is clear. Replaced the oil cap gasket, and it still has oil coming out of it and fails the jiggle test. It does however, draw a vacuum when you rev the motor up, but at idle there is definitely positive pressure coming OUT of the fill hole.
Drained the intercooler at the large hex bolt, and got less than a teaspoon of oil out of it.
So now I am stumped. Any thoughts?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 740t crankcase pressure-stumped! [700]
posted by  superglyde  on Mon Apr 18 03:17 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.